Drag Mouse Over The Image To Zoom View.
Description
VURA FixLoc
VURA FixLoc is a pre-mixed cementitious powder adhesive composed of Portland cement, hydraulic binders, bonding agents, silica sand and special adhesives. It is formulate as a crack free, superior, flexible, high bonding adhesive for AAC Blocks. It can also be used to fix Concrete, Cement blocks, Siporex Blocks and clay bricks to prevent clay absorption of water for adhesive mix. It is a masonry mortar for use in laying bricks, block.
CHARACTERISTICS
- Easy to mix and apply, just add water
- High bonding strength
- Flexible, shock and impact resistance
- Crack resistant
- No curing is required
- Can be applied in thin jointing with high adhesion
- Ideal for internal and external application
- Excellent strength and adhesion between panels
- Suitable for hot weather
- Suitable for concrete blocks, AAC blocks, Siporex blocks, Hollow blocks, Cement mortar blocks / bricks
Documents & Downloads
Usage Guide
SUBSTRATE PREPARATION
The block side surfaces should be free of lose particles, dust, dirt, grease, oil. Spray the panel side surface with water before applying the mix. If expansion joints exist, do not cover with adhesive. Follow the specifications for the requirements for expansion joints.
APPLICATION
Apply a layer of VURA FixLoc mix to the horizontal and vertical side surface of the panel/black using a 6mm toothed trowel. Apply the adhesive to a one panel/block at a time. Position the AAC panel/block gently and use rubber mallet for tapping and a spirit level to check for alignment
Apply VURA FixLoc in thin layer (2 to 3mm) to enable the continuity of the thermos-insulation of the AAC blocks. Pay attention that the applied layer does not form a superficial film before fixing the block. If this occurs, apply a fresh new layer.
Leave a space of about 1-2 cm between the top of the block wall and the bottom of slab or beam in order to avoid formation of cracks along the wall. The cavity should be filled with compressible material.
Plastering could be applied to AAC walls after 24 hours of fixing the panels/blocks
Description
VURA FixLoc
VURA FixLoc is a pre-mixed cementitious powder adhesive composed of Portland cement, hydraulic binders, bonding agents, silica sand and special adhesives. It is formulate as a crack free, superior, flexible, high bonding adhesive for AAC Blocks. It can also be used to fix Concrete, Cement blocks, Siporex Blocks and clay bricks to prevent clay absorption of water for adhesive mix. It is a masonry mortar for use in laying bricks, block.
CHARACTERISTICS
SUBSTRATE PREPARATION
The block side surfaces should be free of lose particles, dust, dirt, grease, oil. Spray the panel side surface with water before applying the mix. If expansion joints exist, do not cover with adhesive. Follow the specifications for the requirements for expansion joints.
APPLICATION
Apply a layer of VURA FixLoc mix to the horizontal and vertical side surface of the panel/black using a 6mm toothed trowel. Apply the adhesive to a one panel/block at a time. Position the AAC panel/block gently and use rubber mallet for tapping and a spirit level to check for alignment
Apply VURA FixLoc in thin layer (2 to 3mm) to enable the continuity of the thermos-insulation of the AAC blocks. Pay attention that the applied layer does not form a superficial film before fixing the block. If this occurs, apply a fresh new layer.
Leave a space of about 1-2 cm between the top of the block wall and the bottom of slab or beam in order to avoid formation of cracks along the wall. The cavity should be filled with compressible material.
Plastering could be applied to AAC walls after 24 hours of fixing the panels/blocks
